Going to wire everything up in the basement temporarily so I can try to get it to work.
I still haven't wired the devices in yet.
Also, there is a 6 after each segment which is the zone type which is an instant zone by the chart. Obviously segment 2 is zone 18 and segment 3 is 19 and the rest follow that sequence. Segment 1 is for zone 17 and segment 8 is for zone 24. I figured out that the segments are the zones to program. From the manual the zones I want to use (17-24) are in location 29 so I used that for a location. It then asked me for a device address and I believe I was to use 0#. First, I entered *8, then I entered the user code of 9713. Ok, well i played with it a little bit and must say it's the manual is quite confusing. Anyone know ho to program this into my system? Doesn't look like anyone local wants to do it. I can hard wire all the sensors so I don't need any wireless device. Also would like to add a water sensor in the basement and a sensor that detects if it gets too cold in the house. I'd like to add a garage door sensor with enough time for me to open the door and disarm the system. My system is currently working fine and has a expander card installed with 16 zones used and a few more left open to use. I took a look at the manual online and it doesn't make much sense to me. The installer code has never been changed so I can get into the system. I'm handy and thinking of taking the job on myself. I've been contacting the original installer and a few other installers in the area for a month and know one will call me back. I want to upgrade the system and make a few improvements. I have a Caddx system installed in my home that I had installed when I had my home built ten years ago.
0 kommentar(er)
